News

Ways To Install Sensor Lights In Your Home

These days technology is getting advanced every day, and with time it keeps getting easier for people. Electrical equipment is easier to use and less time-consuming nowadays, which makes things better in every household.

Sensor lights are very famous since they make your job easy and convenient, and you can operate things with the convenience of your bed and remote controls. Here are ways on how to install sensor lights online:

1.Turn Off The Power

Identify the circuit to the light switch that you will replace, and turn the power off at the circuit breaker. As an extra precaution, place a Do Not touch sign outside or near the circuit box so that someone else doesn’t by mistake restore power while you are still working on it.

2.Test The Wires And Remove The Switch

After this, remove the wall plate from the existing switch to test the wires using a circuit tester. There are testers used to ensure no power flowing to the cables you’ll be removed during the process.

With the audible tester, a constant beep would indicate that there is still power. The tester confirms that the power is off. When the power is off, remove the screws that hold the old switch in place.

3.Cut The Wires

The old switch has three wires connected at the back: the black, white wire and bare ground. The black and white wires are connected to the new motion-sensor switch, but the ground is not used.

Make sure you then cut the wires at the back of the old switch, which is an important part of the process.

4.Strip The Black And White Wires

Once you remove the old switch, strip the plastic insulation off the ends of the black and white wires by using wire strippers. Removing these wires is also another step that cannot be removed.

5.Connect The Wires To The New Switch

Once the ends of the wires are stripped, they can be hooked up to the new switch. Wrap the end of the black wire around one of the wire connections on the back of the new button. Repeat the same thing with the white wire.

Secure the wires with wire connectors, so they do not come off or are not loose and stay in place for a certain period.

Visit Here: Comment on Instagram

6.Secure The Switch

After connecting the wires:

  1. Tuck the excess wire into the switch box.
  2. Position it properly into the connected sensor switch into the switch box.
  3. Secure the button with the mounting screws and other screws to tighten it.

7.Reinstall The Wall-plate

After the whole process is done, make sure you put things back in place and adjust the sensitivity and the timing of the light activation. Set all the controls to your preferred settings before installing the wall plate.

Check Legrand out for some high-quality electric equipment, from home theatre systems to switching devices. They have it all, and the best part about them is that they are long-lasting and easy to use.

Read More About: Khatrimaza

Related Articles

Leave a Reply

Back to top button